A thread gauge, also known as a screw gauge or pitch gauge, is used to measure the pitch or lead of a screw thread. Thread pitch gauges are used as a reference tool in determining the pitch of a thread that is on a screw or in a tapped hole To use a thread gauge, the user must first match the type of thread to the gauge. For example, attempting to measure metric threads with an imperial gauge will not return accurate results. To determine the correct gauge, a process of trial and error may be needed if the screw is of unknown origin. Once the correct gauge is determined, the user should extend one of the leaves of the tool and press it against the threaded portion of a screw. If the teeth (cut into the leaf) match the spacing of the thread, then the user can read off the thread pitch stamped into the leaf. If the fit is not good, the user should try a different leaf. Note that this tool is not for accurate measurement of an unknown thread, such as a hand-turned thread from a lathe. This tool is meant for a best-approximation measurement to a known thread standard. & Used to check thread angle and pitch of thread cutting tools. / Use to grind and position thread cutting tool on a lathe 55 degree angle, tempered with a satin-chrome finish Extremely handy for use in grinding and setting screw cutting tools / Hardened with lapped edges and notches Very useful for finding number of threads per inch through graduations in 1/14″ and 1/20″ of an inch on center gauge Ground gauging surfaces